APPLICATIONS [SD90000] Express Mode Default Value = T Valid Entries = T, F Read by Graphical Dispatch Board (SD.900.00). When set to T, a single instance of the Service Call entry screen will be used to display any service calls you select to open. When set to F, a new instance of the Service Call entry screen will be launched for each service call you select to open. [Report-{scrnnbr}] ZoomPercent Default Value = read from the .rpt Valid Values = 0-500 Sets the default zoom percent when print previewing a crystal report. For example, adding the following settings would set the GL Detail General Ledger (01.620) report to default to a 300% zoom level, and the GL Trial Balance report (01.610) report to a 200% zoom level: [Report-01620] ZoomPercent=300 [Report-01610] ZoomPercent=200 [CRUFLADG] Logging Default value = N Valid Entries=Y, N When set to Y, certain crystal functions used in various distribution reports may write logging entries to a file called CRUFLADG.LOG in the users’ application data folder. This setting may be used for troubleshooting. It is not recommended to leave this setting set to Y. [Miscellaneous] RateDecimalPlaces Default value = 9 Valid Entries = 8 or 9 Read by Currency Selection (24.000.00). Enables the rate to allow up to either 8 or 9 decimal places. AccountDetail Default value = 5000 Valid Entries = 2 – 99999 Limits the number of records that display in the detail grid of the Account History Detail (01.300.01) subscreen of the Account History (01.300.00) screen. SiteIDValidation Default Value = OFF Valid Entries = On / Off When set to ON, performance can be improved when opening the possible values list on the site field in various inventory and order management screens. This primarily helps when there are a large number of inventory items. However when enabled, you will no longer see the "Active Site for this item" column in the possible values list. ReleaseByScrnNbr Default Value = OFF Valid Entries = On / Off If set to ON, then the Inventory Release (10.400.00) screen will sort the grid of unreleased batches by screen number (batch.editscrnnbr) and then batch number. If set to OFF, the Inventory Release screen will sort the grid of unreleased batches by batch number only.
↧
Undocumented Solomon.ini settings (part 3)
↧